• 3D Printer Stepper Motor Driver, FYSETC Upgrade TMC2208 V1.0 Stepper Driver Module Carrier with Heat Sink Screwdriver for 3D Printer Controller Mother Boards Reprap MKS Prusa i3 Ender-3 Pro, White

  • Specifications
    #Interface: Step/Dir
    1. Configuration: CFG Pins or UART
    2. Native Microsteps: up to 1/256
    3. MicroPlyer Microsteps: 1/256
    4. Logic Voltage (VIO): 3-5V
    5. Motor Voltage (VM): 5.5-36V
    6. Motor Phase Current max: 1.2A RMS, 2.0A Peak. Therefore, the reference voltage of the driver module should not exceed 1V. At the same time, the driver module must be dissipated, otherwise it will affect the life of the driver module.
    7. Internal V- Regulator: enabled
    8. RDSon: ≤0.3 Ohm
    9. StealthChop (quiet): yes
    10. SpreadCycle: yes
    11. CoolStep: no
    12. StallGuard: no
    13. DcStep: no

    #Motor Current Setting
    ●The best way to set the motor current is by measuring the voltage on the Vref pin (0...2.5V) and adjusting the voltage with the potentiometer. The maximum settable motor current is 1.77A RMS (0.1...read more
  • Manufacturer: FYSETC
  • More products from seller: Amazon
  • Your price: USD 12.99
      (as of 2019-02-01 19:20 UTC - More info)
  • As an Amazon Associate we earn from qualifying purchases.
  • Note: Prices are subject to change at anytime
  • Click here to buy at
    Amazon
Here some other interesting products:
Here some other interesting products: